The Z-Shaft assembly should never be disassembled by other than factory authorized personnel. There are no user or field technician serviceable parts on the z-shaft assembly. Service all z-drive components only by using the procedures contained in these instructions.
|
|
CAUTION!! Do not disassemble any parts physically connected to the z-shaft itself, except as provided in the following instructions. Installation and assembly of the z-shaft assembly requires special training and tools and should never be attempted outside of the factory. |
All of the procedures below can be accomplished only by Melco authorized field service technicians. Do not attempt to perform any of the procedures below unless you have received specific training that allows you to do so. Click on the link to get to the procedure.
The following procedures may be performed by the machine operator (click on the link to get to the procedures).
Z-Drive Belt Replacement and Tensioning
Z-Home Optical Sensor PCB Replacement
