|
POSSIBLE CAUSES |
SOLUTIONS |
|
Poor overall embroidery quality |
Make sure the cap is hooped properly |
|
Modify the design |
|
|
Check that the driver was properly adjusted on the peripheral |
|
|
Puckering |
Modify the design |
|
|
|
|
Loss of registration |
|
|
Modify the design |
|
|
Check that the driver was properly adjusted on the peripheral |
|
|
Cap frame is loose on the driver |
|
|
Cap frame driver doesn't fit on the peripheral properly |
Make sure you are using flat needle plates (and not the raised needle plates) |
