2. Lubrication
The Color Change Cam
NOTE: This procedure does not apply to the following peripherals:
EMC 1, CH 1, ADV 18.
EMC 6, EMC 6M, EMC 6ML, EMC 6MLT, EMC 6/4M,EMC 6/4MT, EMC 10, EMC
10T, EMC 10/4, EMC 10/4T:
The color change cam moves the needle case during a color change. The
easiest way to lubricate it is to grease the pins that come in contact with it
when the needle case moves. Some of these pins are accessible when the needle
case is on needle 1, as shown in Figures 2-20 and, follow these steps:
- Move the needle case to the full left position.
- Locate the pins on the back of the needle case.
- Place a small dab of grease on the accessible pins.
- Move the needle case from left to right four or five times to transfer
the grease to the cam.
Figure 2-20
